15 Tools
340
Security Settings
Set the security settings.
SSL/TLS Settings
Configure the SSL/TLS settings.
Device Certificate - Server
Select a certificate for HTTP SSL/TLS communications.
HTTP - SSL/TLS Communication
Select whether or not to enable HTTP SSL/TLS communications.
HTTP - SSL/TLS Port Number
Set the port number used for HTTP SSL/TLS communication from 1 to 65535.
The default value is 443.
Note • Do not use the numbers assigned to the other ports.
LDAP - SSL/TLS Communication
Set whether or not to enable the SSL/TLS communications for authentication and searches.
If you enable the LDAP SSL/TLS communications, you must set [Primary Server Port
Number] and [Secondary Server Port Number] under [LDAP Server/Directory Service
Settings].
The port number for SSL/TLS communications of the LDAP directory server is normally set
to 636.
SMTP-SSL/TLS Communication
Configure the SSL/TLS communications.
• Disabled
The machine does not communicate in SSL/TLS.
• STARTTLS (If Available)
The machine verifies the certificate and communicates in SSL/TLS. If the verification
fails, the machine does not communicate in SSL/TLS.
• STARTTLS
The machine verifies the certificate and communicates in SSL/TLS. If the verification
fails, the machine cannot perform communication.
•SSL/TLS
The machine communicates in SSL/TLS.
ThinPrint-SSL/TLS Communication
Select whether or not to enable the SSL/TLS communications.
Device Certificate - Client
Select a certificate for HTTP SSL/TLS communications.
Verify Remote Server Certificate
When the machine is operated as an SSL client, select whether or not to verify the certificate
of the remote server.
To Next Page
Loading...
Need help?
General