Output Format
111
Paper Size and Stapling Position
• Finisher-AB1
Note • The staple orientation displayed on the touch screen differs from the actual staple orientation. Outputs
are stapled in the orientation shown in the above table.
• When different sized documents are loaded in the document feeder, outputs are stapled only when all
the documents match the document guides. For information on how to copy different sized documents
simultaneously, refer to "Mixed Size Originals (Scanning Different Size Documents Simultaneously)"
(P.89).
ID Card Copy (Copying Both Sides of an ID Card)
This feature allows you to copy both sides of a small undetectable original, such as an ID
card, onto one side of paper.
1
Specify the orientation of the document in
[Original Orientation] on the [Layout
Adjustment] screen.
2
Place the document slightly away from the top left corner of the document glass, and close
the document glass.
Note • Always use the document glass when copying. You cannot use the document feeder with this feature.
• Specify the orientation of the original document correctly.
• If the edges of the image are missing, slightly move the card inward on the document glass so that the
whole image can be scanned.
1 Staple
(Left)
1 Staple
(Right)
A4, B5,
7.25 x 10.5",
8.5 x 10",
8.5 x 11",
8.5 x 13",
8.5 x 14",
16K
To Next Page
Loading...
Need help?
General