Loading Paper
211
Loading Paper in Tray 5 (Bypass Tray)
When printing or copying on a size or type of paper that cannot be set in Trays 1 to 4, use
Tray 5 (bypass tray). The following describes the procedures to load paper in Tray 5. To use
Tray 5 when printing, select Tray 5 and specify the paper type on the [Paper/Output] tab of
the print driver.
Note • To prevent paper jams and erroneous detection of paper loaded in the tray by the machine, do not take
out paper of a package until the tray runs out of paper.
• Carefully fan the paper before loading it in a tray. Otherwise, the paper may stick together, resulting in
paper jams, or multiple sheets being fed to the machine simultaneously.
1
Open Tray 5.
2
Slide the width guides to the edge of the tray.
The width guides should be fully extended.
3
Load paper with the side to be copied or
printed on facing down, inserting the paper
until its edge lightly touches against the paper
feed entrance.
Note • Do not force paper into Tray 5.
• Do not load mixed paper types into the tray.
• Do not load paper above the maximum fill line.
It may cause paper jams or machine
malfunction.
• Depending on the type of the heavyweight
paper, paper may not be fed to the machine or
image quality may deteriorate.
4
Adjust the paper guides to align the edges of
the paper loaded.
5
Instruct a copy or print job.
To Next Page
Loading...
Need help?
General