Loading Paper
209
Loading an Envelope in Trays 1 to 4
The following describes the procedures to load an envelope in Trays 1 to 4.
1
Raise the latch on the handle of the right hand
cover to open the cover.
2
Press down the lever to set the envelope mode.
Note • If you insert media other than envelopes, lift
up the lever.
• To load envelopes using the optional Finisher-
AB1, raise the lever as shown in the
illustration.
• To load print media other than envelopes
using the optional Finisher-AB1, check if the
lever is pulled down as shown in the
illustration.
To Next Page
Loading...
