17 Printer Environment Settings
440
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining
the address. The configuration of an IP address, a subnet mask, and a gateway address is not
required.
For information on how to set an IP address, refer to "Protocol Settings" (P.328).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
6
Print a configuration report to confirm that the IPP port is enabled and that TCP/IP is set
up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.260).
7
Configure other IPP settings as necessary.
Refer to "Dell Printer Configuration Web Tool Setting Items" (P.440).
Step 3 Configuration on the Computer
To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.428).
For information on the driver installation procedures, refer to the manual contained in the Driver CD
Kit.
Dell Printer Configuration Web Tool Setting Items
You can configure the following setting items using Dell Printer Configuration Web Tool:
For information on how to start Dell Printer Configuration Web Tool, refer to "Starting Dell Printer
Configuration Web Tool" (P.420).
• Spool Destination for Jobs
([Properties] > [General Setup] > [Memory Settings] > [IPP])
• Port Settings
• Add Port Number
• TBCP Filter
• Administrator Mode
•DNS
• Connection Time-Out
To Next Page
Loading...
Need help?
General