To Next Page

To Previous Page

15 Tools

396

Enter a speed dial number of broadcast destination (001 to 099) or group number (#01 to

#09) registered on the relay station with the numeric keypad, and then select [Add].

Note • If there are more than one broadcast destinations, repeat step 4.

To print a document also at the relay station, under select [On] for [Print at Relay Station].

Select [Save].

Billing - Day Time, Billing - Night Time, Billing - Midnight

Set the connection time for one unit charge in each of the time bands (daytime/night/

midnight).

You can set a value from 0.1 to 255.9 seconds in 0.1 second increments.

This item is displayed when [Accounting] > [Accounting Type] is set to [Local Accounting] and

[Fax] is set to [Enable Accounting] under [Accounting Mode]. For information on how to enable the

feature, refer to "Accounting Mode" (P.403).

The information registered can be confirmed by printing a Billing Data List. For information about

how to print, refer to "Billing Data List" (P.265).

Select one of [Billing - Day Time], [Billing - Night Time], and [Billing - Midnight].

Select [Billing].

Enter the time for one unit charge from 0.1 to

255.9 seconds in 0.1 second increments with the

numeric keypad.

Select [Save].

When the [Delete Entry] Button is Selected

Selecting this button deletes all the information registered for the address selected. To delete

all information registered, select [Delete].

Note • Deleted information cannot be restored.

Create Fax Group Recipients

You can register addresses for broadcast transmission as a group. Each group can include up

to 20 address numbers. The maximum number of groups that can be registered is 50.

Note that recipients to be added to a group must be registered in the speed dials on the

Address Book.

Note • Even when the speed dial number of fax recipients (address book entries) are included in a group, the

machine does not send faxes to the recipients if their address types are set to [Email] or [Server].

• You cannot include a group in another group.

• You can use wildcards for specifying the numbers in the last one or two digits as shown in the

following example:

- 001*:Specifies the 10 addresses with address numbers 0010 to 0019.

- ****:Specifies all address numbers.

Dell C5765DN User Manual

Other manuals for Dell C5765DN