15 Tools
388
• Resend Attempts
Set the transmission retry count from 1 to 5.
• Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
Name, Server, Save in, User Name, and Password
Select [Name], [Server], [Save in], [User Name], or [Password] to display an input screen.
The numbers of characters you can input are as follows:
• Name: Up to 36 single-byte characters
• Server: Up to 64 single-byte characters
• Save in: Up to 128 single-byte characters
• User Name: Up to 97 single-byte characters
• Password: Up to 32 single-byte characters
Transfer via SMB (1), Transfer via SMB (2)
Specify where SMB forwarding is to be stored.
[Transfer via SMB (2)] will be displayed when [Transfer via SMB (1)] is configured.
Address Book
When the server address is registered on the Address Book, you can specify the address from
the Address Book. The specified address appears in the [Transfer via SMB (1)] or [Transfer
via SMB (2)] screen.
For more information on the Address Book, refer to "Add Address Book Entry" (P.390).
File Format
Specify an output file format.
Resend Attempts
Set whether or not to try sending again if a transmission fails. If you select [On], set the
number of resend attempts and interval.
• Resend Attempts
Set the transmission retry count from 1 to 5.
• Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
Name, Server, Shared Name, Save in, User Name, and Password
Select [Name], [Server], [Shared Name], [Save in], [User Name], or [Password] to display
an input screen.
The numbers of characters you can input are as follows:
• Name: Up to 36 single-byte characters
• Server: Up to 64 single-byte characters
• Shared Name: Up to 64 single-byte characters
• Save in: Up to 128 single-byte characters
To Next Page
Loading...
