15 Tools
394
Password
Set a password when the forwarding destination server prompts a password entry. You can
enter up to 32 single-byte characters for a password.
Port Number
Set the forwarding destination port number. Specify a number from 1 to 65535.
Fax Number
Enter a fax number with up to 128 digits.
Index
You can register a single alphanumeric index character for use as a keyword to search with
the Address Book.
Starting Rate
Set a communications mode. You can select either [G3 Auto] or [Forced 4800 bps].
When the destination is specified by a speed dial number with the communications mode
set, you cannot change the communications mode in the [Fax] screen.
Resolution
Set image quality for transmission.
Select from [Panel] (image quality selected on the control panel), [Standard (200x100 dpi)],
[Fine (200 dpi)], [Superfine (400 dpi)], or [Superfine (600 dpi)].
Cover Page
Select whether or not to send a fax with a cover note attached. If attached, specify comments
on the sender and a recipient to be printed in the cover pages.
Comments must be registered in advance.
For information on comment registration, refer to "Add Fax Comment" (P.397).
1
Select [Print Cover Page].
2
Select [Comments].
3
Select any comment from the list of comments
displayed under [Recipient's Comment] and
[Sender's Comment].
Note • Select [ ] to display the previous screen or
[ ] to display the next screen.
4
Select [Save]. The image of the Fax Cover Page
is displayed.
5
Select [Save].
Maximum Image Size
Select the maximum image size to match the recipient's paper size or available profile.
To Next Page
Loading...
Need help?
General