Dell C5765DN - Page 587

Status Code
587
024-747
[Cause] Incompatible print parameters are used. The combination of the specified features such
as Document Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is
incompatible.
[Remedy] Confirm the print data, and try printing again.
024-748
[Cause] The number of digits specified in [Bates Stamp - Number of Digits] screen does not
match the value specified in [Starting Number].
[Remedy] Set [Bates Stamp - Number of Digits] to the value specified in [Starting Number] or to
[Auto Assign].
024-775
[Cause] Booklet printing was specified for printer properties, but the number of print pages for
the job exceeded the maximum number allowed for booklet creation.
[Remedy] Change the printer properties setting to split the pages appropriately to create separate
volumes, or to cancel the booklet creation setting.
025-596
025-597
[Cause] An error occurred with the hard disk.
[Remedy] Replace the hard disk.
026-700
[Cause] By Address Book operation, the machine received an unsupported protocol from the
LDAP server.
[Remedy] Execute the operation again. If the error still is not resolved, contact Customer Support
at dell.com/contactdell.
026-701
[Cause] The number of queries submitted to the Address Book exceeded the machine's
processing capability.
[Remedy] Wait for a while and execute the operation again. If the only one query is being
submitted to the Address Book, the machine's software may be defective. Contact
customer support.
026-702
[Cause] The number of accesses from the LDAP server to the machine by Address Book
operation exceeded the machine's processing capability.
[Remedy] Wait for a while and execute the operation again. If the error still is not resolved, contact
Customer Support at dell.com/contactdell.
026-703
[Cause] Authentication is canceled when adding documents during faxing or scanning.
[Remedy] Authenticate when adding documents.
026-708
[Cause] Exceeded the maximum limit for the scan data size that can be stored for one job with
Store & Send Link.
[Remedy] Take one of the following measures:
1)Reduce the resolution (scan quality) of the scan parameters and execute the operation
again.
2)Reduce the image with magnification of the scan parameters (such as A3 > A4) and
then execute the operation again.
3)If [Store & Send Link - Maximum File Size] is set to a small value, increase the value.
026-709
[Cause] The capacity of the hard disk that can be used to store scan data with Store & Send Link
is insufficient.
[Remedy] Wait around one day, and when capacity becomes available as a result of the automatic
deletion of files, execute the operation again.
026-710
[Cause] The machine has received an e-mail encrypted by S/MIME, but does not support the
encryption method.
[Remedy] Take one of the following measures:
• Ask the sender to send the e-mail encrypted by 3DES.
• Disable the FIPS140 validation mode of the machine.
Status Code Cause and Remedy