Configuration for Authentication
557
7
Select [Login to Remote Accounts], and then select [Save].
For more information, refer to "Login Type" (P.451).
8
Select [Yes].
9
Select [Access Control].
10
Select [Service Access].
11
Select [Unlocked] for the required services to permit users unlimited access, and then select
[Save].
12
Select [Close] repeatedly until the [Tools] screen is displayed.
13
Select [System Settings].
14
Select [Connectivity & Network Setup].
15
Select [Remote Authentication/Directory Service].
16
Select [Authentication System Setup] > [Authentication System], and then select a
remote authentication server.
For more information, refer to "Remote Authentication/Directory Service" (P.369).
Note • The available options are [Kerberos (Windows 2000)], [Kerberos (Solaris)], [LDAP], [SMB], and
[Authentication Agent].
17
Configure the settings for the remote authentication server.
For more information on the Authentication feature, refer to "Kerberos Server Settings" (P.369),
"LDAP Server/Directory Service Settings" (P.370), and "SMB Server Settings" (P.374).
18
Select [Close] repeatedly until the [Tools] screen is displayed.
19
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
• The machine enters the Login mode, and [Login] is displayed at the lower left of the [Home] screen.
• When [Locked (Show Icon)] is selected for a service under [Service Access], [ ] is displayed on the
button of the applicable service on the [Home] screen. Also, [ : Requires Login] is displayed at the
lower left of the [Home] screen. [ ] and [ : Requires Login] are not displayed after authentication.
• When [Locked (Hide Icon)] is selected for a service under [Service Access] the applicable service is
not displayed on the [Home] screen. The services is displayed after authentication.
When an LDAP server is used as a remote authentication server
Set the user authorization on the LDAP server using the following steps.
1
Start Dell Printer Configuration Web Tool.
2
Click the [Properties] tab.
3
Click [Connectivity] > [Protocols] > [LDAP] > [LDAP Authorization Access].
4
Set attributes in [System Administrator Access] and [Accounting Administrator Access].
Setting example:
System Administrator Access: CN=SA,CN=Users,DC=secEQ,DC=local
Accounting Administrator Access: CN=AA,CN=Users,DC=secEQ,DC=local
5
Click [Apply].
To Next Page
Loading...
Need help?
General