Dell EMC ML3 User Manual

Table 36. Warning events (continued)
Event Code Message Text and Description Details and Solution
4060 Connection to the KMIP server failed.
v Verify the user name and password and all
needed SSL certificates that are needed for
connecting to the KMIP server.
v Verify that the KMIP server is reachable within
the network.
v Verify the IP addresses and host names of the
KMIP servers that are entered into the wizard.
4061 Key is not found on KMIP server. Verify that the requested key is available on the
KMIP server. Check the KMIP server logs for
details.
4062 Key creation on KMIP server failed. Check the KMIP server logs for details about
why key creation failed.
4063 KMIP configuration invalid. Use the KMIP configuration wizard to verify the
KMIP configuration.
4065 A tape alert flag was reported by a drive. Look for logged TapeAlert flags and see its
description in the “TapeAlert flags” on page 95
section.
4067 Cleaning cartridge will soon expire and must
be replaced.
Replace the cartridge.
4072 No cleaning cartridge in logical library
available for auto cleaning
v Auto cleaning is enabled, but the logical
library contains no labeled cleaning cartridge.
The library was unable to complete the auto
clean function for one or more drives in this
logical library.
v Install a valid and labeled cleaning cartridge
into the logical library and then complete a
load and unload on the drive that needs
cleaned to initiate the auto cleaning.
4073 Medium source element empty. Check the source slot visually and rescan the
inventory. Additionally, check for valid and
readable bar code label.
4074 Medium source element empty. Check the source slot visually and rescan the
inventory. Additionally, check for valid and
readable bar code label.
4075 Cartridge lost while it was extracted from
slot/drive.
Check the source/destination element and ensure
that no obstructions are in the pathway of the
accessor.
4077 Unlocking the right magazine failed.
v Restart the library and retry the operation.
v If the error persists, replace the chassis.
v If the magazine needs to be removed to get
access to the tape cartridges, first power down
the device, and then release the magazine
manually. Only one magazine can be open at a
time.
Troubleshooting 89

Dell EMC ML3 Specifications

General

Number of Drives	1
Category	Tape Library
Drive Technology	LTO
Humidity	20% to 80% (non-condensing)
Drive Type	LTO Ultrium
Maximum Capacity	15 TB (compressed)
Interface	6Gb/s SAS
Max Data Transfer Rate	up to 750 MB/s (with compression)
Operating Temperature	10°C to 35°C
Non-operating Temperature	-40°F to 140°F (-40°C to 60°C)