Figure 66. Installing the front perc module
Next steps
1. Slide in the drive cage.
2. Replace the drive backplane.
3. Connect the drive backplane cables to the connectors on the system board and backplane.
4. Replace the drives.
5. Replace the air shroud
6. Replace the cooling fan cage assembly.
7. Replace the front top cover.
8. Follow the procedure listed in After working inside your system.
Removing the PERC module from PERC tray
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Remove the drive backplane.
9. Slide out the drive cage.
10. Remove the front perc module.
Steps
1. Disconnect the battery power cable from the PERC card.
2. Tilt and lift the battery holder assembly from the front PERC tray.
NOTE: Remove the battery cable from the front PERC shroud cable holder.
Installing and removing system components 101
To Next Page
Loading...
