Next steps
1. Replace the BOSS-N1 module.
Installing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Observe and disconnect the cables from the connectors on the power distribution board.
7. Remove the PSU(s).
8. Remove the PSU cage.
Steps
1. Align the BOSS-N1 module at an angle with the controller card module slot.
2. Insert the BOSS-N1 module and push the module horizontally toward the rear of the system until firmly seated.
3. Using the Phillips 1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screw.
4. Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Figure 106. Connecting the BOSS-N1 power and signal cables to the BOSS-N1 module
5. Connect the BOSS-N1 power and signal cable to the connectors on the system board.
136
Installing and removing system components
To Next Page
Loading...
