Installing the H100/H800 baseboard
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the GPU fan cage.
4. Remove the GPU tray.
5. Remove the GPU top cover.
NOTE: For GPU and heatsink module installation, it is required to use an ESD-Safe Torque screwdriver holding a T15 bit
with a narrow shaft that is at least 15cm (6 inches) in length.
Steps
1. Align the GPU base board with the guiding pins and carefully insert it onto the GPU tray in a top-to-bottom direction.
Figure 167. Installing the H100/H800 baseboard
2. Using a Torx 15 screwdriver, hand-tighten the 17 captive screws down in the order shown. Then, utilize the Torque
screwdriver in the same order and set the final torque at 6.0 +/- 10% lbf-in or 0.68 +/- 10% N-m.
Installing and removing system components
185
To Next Page
Loading...
