Figure 109. Installing the BOSS-N1card carrier
Next steps
1. Follow the procedure listed in the After working inside your system.
Removing the BOSS cage
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If installed, remove the OCP blank.
Steps
1. Disconnect the intrusion cable from rear I/O board.
2. Using both hands, pull up the plunger and hold the BOSS cage.
3. Slide the BOSS cage toward the rear of the system to unlock from key slot.
4. Lift the BOSS cage from the system.
138
Installing and removing system components
To Next Page
Loading...
