Next steps
1. Replace the psb top cover.
2. Replace the drive cage.
3. Slide in the drive cage.
4. Connect the drive backplane cables to the connectors on the system board and backplane.
5. Replace the drives.
6. Replace the air shroud
7. Replace the cooling fan cage assembly.
8. Replace the front top cover.
9. Follow the procedure listed in After working inside your system.
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Slide out the drive cage.
9. Remove the drive cage.
10. Remove the psb top cover.
Steps
1. Using the Torx 8 screwdriver, remove the screws that secure the left control panel and the cable cover to the system.
2. Remove the cable cover away from the system.
3. Disconnect the control panel cable from the connector on the system board.
4. Holding the cable, slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the left control panel from the system.
202 Installing and removing system components
To Next Page
Loading...
