Figure 64. Installing the metal plates to drive cage
Next steps
1. Slide in the drive cage.
2. Replace the drive backplane.
3. Connect the drive backplane cables to the connectors on the system board and backplane.
4. Replace the drives.
5. Replace the air shroud
6. Replace the cooling fan cage assembly.
7. Replace the front top cover.
8. Follow the procedure listed in After working inside your system.
PERC module
This is a service technician replaceable part only.
Removing the front perc module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Remove the drive backplane.
9. Slide out the drive cage.
Steps
1. Pull to unlock the plunger on the metal tray of front perc module and slide towards left of the system.
2. Lift the front perc module from the system.
Installing and removing system components
99
To Next Page
Loading...
