Figure 69. Removing the PERC card from PERC tray
NOTE: The procedure to remove the other PERC card is similar.
Next steps
1. Replace the PERC module on PERC tray.
Installing the PERC module on PERC tray
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Remove the drive backplane.
9. Slide out the drive cage.
10. Remove the front perc module.
Steps
1. Align and install PERC card to the guides on the front PERC tray.
2. Align and Install the PERC shroud on the PERC card.
3. Using a Phillips #2 screwdriver, tighten the four screws to secure the PERC shroud to the PERC tray.
Installing and removing system components
103
To Next Page
Loading...
