Figure 60. Sliding in the drive cage
Next steps
1. Replace the drive backplane.
2. Connect the drive backplane cables to the connectors on the system board and backplane.
3. Replace the drives.
4. Replace the air shroud
5. Replace the cooling fan cage assembly.
6. Replace the front top cover.
7. Follow the procedure listed in After working inside your system.
Removing the drive cage
This is a service technician replaceable part only.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Remove the drive backplane.
9. Slide out the drive cage.
Steps
1. Using Phillips 2 screwdriver, release four capture screws securing the drive cage with metal plates on both side of the
chassis.
96
Installing and removing system components
To Next Page
Loading...
