Figure 79. Installing the PSB top cover
Next steps
1. If required, install the front PERC module.
2. Slide in the drive cage.
3. Connect the drive backplane cables to the connectors on the system board and backplane.
4. Replace the drives.
5. Replace the air shroud
6. Replace the cooling fan cage assembly.
7. Replace the front top cover.
8. Follow the procedure listed in After working inside your system.
Removing the PCIe Switch Board module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Slide out the drive cage.
9. If required, remove the front PERC module.
10. Remove the PSB top cover.
11. Observe and disconnect the cables connected to PSB module from system board.
Steps
1. Push the PSB handle toward rear of the chassis, to disengage it from the PBB slot.
2. Lift the PSB module from the chassis.
Installing and removing system components
113
To Next Page
Loading...
