Figure 101. Installing the intrusion switch module
Next steps
1. Replace the PSU cage.
2. Observe and connect the cables to the connectors on the power distribution board.
3. Replace the air shroud
4. Replace the cooling fan cage assembly.
5. Replace the front top cover.
6. Follow the procedure listed in After working inside your system.
Optional BOSS-N1 module
Removing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Observe and disconnect the cables from the connectors on the power distribution board.
7. Remove the PSU(s).
8. Remove the PSU cage.
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
Installing and removing system components
133
To Next Page
Loading...
