3. Using a Phillips #2 screwdriver, tighten the captive screw on the EDSFF E3.S backplane module.
Figure 58. Installing the EDSFF E3.S backplane module
Next steps
1. Connect the drive backplane cables to the connectors on the system board and backplane.
2. Install the drives.
3. Install the air shroud
4. Install the cooling fan cage assembly.
5. Install the front top cover.
6. Follow the procedure listed in After working inside your system.
Drive cage
Sliding out the drive cage
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Remove the drive backplane.
Steps
1. Using a Phillips 2 screwdriver, release the three thumb screws on the drive cage.
2. Slide the drive cage toward the front of the chassis.
94
Installing and removing system components
To Next Page
Loading...
