Installing an expansion card into the NIC slots on PCIe Base Board
module
Slots 31 and 40 are present on PCIe Base Board and can be used to install NICs.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Slide out the drive cage.
9. If required, remove the front PERC module.
10. Remove the PSB top cover.
11. Observe and disconnect the cables connected to PSB module from system board.
Steps
1. If installed, remove the filler bracket.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
Figure 89. Removing the filler bracket
2. Hold the card by edges, and align the card with the connector on the PBB board.
3. Insert the card firmly into the PBB board connector until seated.
NOTE:
After installing the NIC card, insert the PSB1 module and connect associated cables for Slot 40; for Slot 31,
insert the PSB4 module and connect associated cables.
Installing and removing system components 121
To Next Page
Loading...
