Figure 85. Installing an expansion card into the PSB module
Next steps
1. Connect the cables to PSB module from system board.
2. Replace the PSB top cover.
3. If required, install the front PERC module.
4. Slide in the drive cage.
5. Connect the drive backplane cables to the connectors on the system board and backplane.
6. Replace the drives.
7. Replace the air shroud
8. Replace the cooling fan cage assembly.
9. Replace the front top cover.
10. Follow the procedure listed in After working inside your system.
11. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the NIC slots on PCIe Base Board
module
Slots 31 and 40 are present on PCIe Base Board and can be used to install NICs.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Slide out the drive cage.
9. If required, remove the front PERC module.
10. Remove the PSB top cover.
118
Installing and removing system components
To Next Page
Loading...
