Installing and removing system components
Topics:
• Safety instructions
•
Before working inside your system
• After working inside your system
• Recommended tools
• Optional front bezel
• System cover
• Front top cover
• Cooling fans
• Air shroud
• Side wall brackets
• Drives
• Drive backplane
• Drive cage
• PERC module
• Cable routing
• Expansion cards and expansion card risers
• Power supply unit
• PSU cage
• Power interposer board
• Intrusion switch
• Optional BOSS-N1 module
• System memory
• Processor and heat sink module
• GPU fans and cage
• GPU tray
• GPU modules
• System battery
• Trusted Platform Module
• System board
• Optional OCP card
• LOM card, MIC card, and rear I/O board
• Control panel
Safety instructions
NOTE:
Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the system by
yourself.
CAUTION: Ensure that two or more people lift the system horizontally from the box and place it on a flat
surface, rack lift, or into the rails.
WARNING: Opening or removing the system cover while the system is powered on may expose you to a risk of
electric shock.
WARNING: Do not operate the system without the cover for a duration exceeding five minutes. Operating the
system without the system cover can result in component damage.
7
64 Installing and removing system components
To Next Page