Dell PowerEdge XE9680 - LOM Card, MIC Card, and Rear I;O Board

LOM card, MIC card, and rear I/O board
Removing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the cooling fan cage assembly.
4. Remove the air shroud.
5. Observe and disconnect the cables from the connectors on the power distribution board.
6. Remove the PSU cage.
7. Remove the BOSS cage.
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) card and rear I/O board to
the system board.
2. Holding the edges, pull the LOM card or rear I/O board to disconnect from the connector on the system board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 179. Removing the LOM card
Installing and removing system components
197