2. Follow the procedure listed in the Before working inside your system.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
Steps
1. If installed, remove the filler bracket.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
2. Open the blue latch on the system board.
3. Slide the OCP card into the slot in the system.
4. Push until the OCP card is connected to the connector on the system board.
5. Close the blue latch to lock the OCP card to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 178. Installing the OCP card
Next steps
1. Replace the BOSS cage.
2. Replace the PSU cage.
3. Observe and connect the cables to the connectors on the power distribution board.
4. Replace the system cover.
5. Follow the procedure listed in After working inside your system.
196
Installing and removing system components
To Next Page
Loading...
