CAUTION: Applying too much thermal grease can result in excess grease coming in contact with and
contaminating the processor socket.
NOTE: The thermal grease syringe is intended for single use only. Dispose the syringe after you use it.
Figure 121. Applying thermal grease
6. For new heat sink, remove the Thermal Interface Material (TIM) protective film from the base of heat sink.
Figure 122. Removing the Thermal Interface Material (TIM) protective film
7. Place the heat sink on the processor and press the base of the heat sink until the retaining clip locks onto the heat sink at all
the four corners.
CAUTION: To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE:
● Ensure latching features on retaining clip, and heat sink are aligned during assembly.
150 Installing and removing system components
To Next Page
Loading...
