NOTE: If the battery does not pop out, then lift it out of the socket.
Figure 172. Removing the system battery
2. To install a new system battery, hold the battery with the positive side facing up and slide it under the socket battery latch.
3. Press the battery into the connector until it snaps into place.
Figure 173. Installing the system battery
Next steps
1. Observe and connect the cables from the connectors on the power distribution board.
2. Install the air shroud.
3. Install the cooling fan cage assembly .
4. Follow the procedure listed in After working inside your system.
5. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, check the time and date at least an hour after installing the battery.
e. Enter the System Setup and if the time and date are still incorrect, see Getting help section.
Installing and removing system components
189
To Next Page
Loading...
