Field Service Ver. 1.0 Apr. 2005 10. Service Mode
103
ineo 161
ineo 210
Adjustment / Setting
C. ATDC AUTO ADJUST
D. PRINT TEST PATTERN
<PATT ERN1 >
<PATT ERN2 >
E. ADF FEED TEST
F. COPY ADF GLASS AREA
Purpose/Use To make an automatic adjustment of the ATDC Sensor.
✽ At setup
✽ When developer has been changed
✽ When IU has been replaced
Setting/
Procedure
<Step>
1. Press the [Yes] key to start the adjustment.
2. The adjustment sequence automatically stops as soon as the adjustment is made.
✽ The sequence may be interrupted using the Stop key.
Purpose/Use To produce a test pattern for image adjustments.
✽ When skew, registration, or zoom ratio has been adjusted
Setting/
Procedure
<Step>
1. Select the paper source.
TRAY1 TRAY2
2. Select the type of test pattern.
3. Press the Start key to let the copier produce the test pattern.
Purpose/Use To produce halftone and gradation test patterns.
✽ When checking for uneven density or uneven pitch
✽ When checking for gradation reproducibility
Setting/
Procedure
<Step>
1. Select the paper source.
TRAY1 TRAY2
2. Select the type of test pattern.
3. Press the Start key to let the copier produce the test pattern.
Purpose/Use • To check for correct paper passage of the paper take-up and transport system in the
Automatic (Duplexing) Document Feeder alone as a single unit.
• Here are the details of operation involved in the paper passage motion.
• The Scanner does not make any scan motion.
• Paper passage operation continues until all pages of the document loaded in the
unit have been fed in.
✽ When a paper misfeed of originals occurs
Setting/
Procedure
✽ Refer to the option service manual (DF-502, DF-605) for details.
Purpose/Use To check for scratches and dirt on the Original Scanning Glass.
✽ When a dirty image occurs
Setting/
Procedure
✽ Refer to the option service manual (DF-502, DF-605) for details.
To Next Page
Loading...
