Digi SM-720 - Page 150

SM-500V2 Service Manual Edition 5
148
3: 10 SECS
SPEC 614: SELECTION OF ZERO SETTING RANGES WHEN WEIGHT RESET SWITCH IS ON OR ZERO
TRACKING
0: ±10% OF CAPACITY ( POWER ON START POINT ± 6000IR )
1: ±5% OF CAPACITY ( POWER ON START POINT ± 3000IR)
2: ±2% OF CAPACITY ( POWER ON START POINT ± 1200IR)
3: ±0.6% OF CAPACITY ( POWER ON START POINT ± 360IR)
SPEC 615: SELECTION OF CAPACITY
0: 3Kg
1: 6Kg
2: 15Kg
3: 30Kg
4: 30LB
SPEC 616: SELECTION OF WEIGHT DUAL / SINGLE RANGE
0: SINGLE
1: DUAL
2: 1 / 7500 OR 1 / 6000
SPEC 617: NEW AD
0: NO
1: YES
SPEC 618: SELECTION OF NET / GROSS DUAL RANGE
0: GROSS DUAL RANGE METHOD
1: NET DUAL RANGE METHOD
SPEC 619: SELECTION OF PLU WEIGHT ITEM COMMODITY NAME DISPLAY ( BENCH TYPE )
0: FULL DISPLAY
1: HALF DISPLAY
2: NO DISPLAY
SPEC 620: SELECTION OF TARE ACCUMULATION
0: ALLOW
1: INHIBIT
SPEC 621: SELECTION OF TARE SUBTRACTION
0: ALLOW
1: INHIBIT
SPEC 622: SELECTION OF MANUAL CLEAR OF TARE
0: ALLOW
1: INHIBIT
SPEC 623: SELECTION OF WEIGHT RESET OPERATION DURING TARE
0: ALLOW
1: INHIBIT
SPEC 624: ZERO TRACKING DURING TARE
0: ALLOW
1: INHIBIT
SPEC 625: SELECTION OF ACCUMULATION WHEN TARE
0: ALLOW
1: INHIBIT
SPEC 626: SELECTION OF DIGITAL TARE
0: ALLOW
1: INHIBIT
SPEC 627: SELECTION OF DECIMAL POINT FIGURE
0: PERIOD