Digi SM-720 - Page 151

SM-500V2 Service Manual Edition 5
149
1: COMMA
SPEC 628: SELECTION OF PRICE ROUNDING METHODS FOR THE DECIMAL DIGITS FOR WEIGHED
ITEMS
0: ROUNDING
1: TRUNCATING
2: CUT UP
SPEC 629: SELECTION OF ADDITIONAL PRICE ROUNDING METHOD FOR ITEM
0: NO ADDITIONAL ROUNDING
1: 1 / 4 ROUNDING
2: SPECIAL ROUNDING
3: ROUNDING FOR 1 ST DIGIT
4: CUT OFF
5: CUT UP
SPEC 630: SELECTION OF AUTO CLEAR OF UNIT PRICE
0: INHIBIT
1: ALLOW
SPEC 631: SELECTION OF MAXIMUM CAPACITY
0: CAPACITY + 1 D
1: CAPACITY + 9 D
SPEC 632: SELECTION OF TARE VALUE EXCHANGE
0: ALLOW
1: INHIBIT
SPEC 633: SELECTION OF AUTO CLEAR OF TARE
0: INHIBIT
1: ALLOW
SPEC 634: SELECTION OF AUTO TARE CLEAR WHEN REZERO
0: INHIBIT
1: ALLOW
SPEC 635: SELECTION OF TRIGGER POINT OF TARE / UNIT PRICE AUTO CLEAR
0: OVER NET 5d & OVER GROSS 21d & WEIGHT STABILITY
1: > = NET 1d AND WEIGHT STABILITY
2: > = NET 1d AND PRICE > 0 AND WEIGHT STABILITY
SPEC 636: SELECTION OF AUTOMATIC ZERO RESET
0: INHIBIT
1: ALLOW
SPEC 637: SELECTION OF NEGATIVE WEIGHT TARE CLEAR
0: ALLOW
1: INHIBIT
SPEC 638: SELECTION OF TARE RANGE
0: LESS THAN 50 % OF CAPACITY
1: LESS THAN 5 % OF CAPACITY
3: MAX 200G
2: NOT USED
SPEC 639: SELECTION OF EXIT FROM ACCUMULATION MODE WHEN WEIGHT CHANGE
0: INHIBIT
1: ALLOW
SPEC 640: SELECTION OF PRICE ACCUMULATION WITH WEIGHT CHANGE > ± 10d
0: INHIBIT
1: ALLOW
SPEC 641: ACCUMULATION AVAILABLE ONLY AFTER SCALE SHOWS WEIGHT = ' 0 '
0: INHIBIT