Digi SM-720 - User Specification Setup; Item Barcode Selection Setup

SM720 Service Manual Edition 5
22
KEY TO PRESS OPERATION
[0] To [1]
-- Select label length.
OR
&
-- Select label length.
Then
-- To set the label length.
Key to press Operation
-- Reading Country Specification.
READING COUNTRY SPEC.
Key to press Operation
-- After Reading Country Spec, the display will
prompt MEMORY CLEAR message.
MEMORY CLEAR?
YES: / NO:
Key to press Operation
If Yes,
-- Process of initialize.
-- Then go to segment check.
PLEASE WAIT
Key to press Operation
If No,
-- Go to segment check.
SM720 VER 29.XXX
SELECT LABEL LENGTH
ENTER LABEL LENGTH NUMBER & PRESS PRINT KEY
Label Length:
0: Short
ÆLabel length up to
maximum 120mm.
1: Long
ÆLabel length up to
maximum 240mm
0 SHORT
CLEAR KEY
TARE KEY