Figure 6.36: IEC UPD Controller Board
Figure 6.37: Remove Controller Board From Panel
6.13.2 Unit Price Display Glass Panel
To replace the display glass panel, the payment terminal will be removed. This is necessary to
release the latches as shown in Fig 6.39, and, more importantly, to properly install the new
panel - it takes some force to re-latch the panel. Be sure the new panel latches snap into place
when installing.
1
Place the SPM into Maintenance mode. Refer to the iX Pay™ SPM manual if necessary.
2
Turn off power to the dispenser at the circuit breaker inside the building. This is necessary
since some connections are made to the dispenser connection board. See Warning at the
beginning of this section.
3
Remove all PTS buttons. Place fingers up inside the button, push up, and then pull out. See
previous Fig 6.33.
110 WM048523 Rev 08 01/2019
6 Replacement Procedures
To Next Page
Loading...
