14 Models with Metal Electronic Head - IEC
This section contains service information and replacement procedures for components that are
specific to dispenser models that have the metal electronic head. Also see Section 4 in this
manual for additional details on boards used in metal head models.
An example model of the metal head is shown in Fig 14.1.
Figure 14.1: Metal head VGA media model with preset keypad
Remove power from the dispenser before performing any of the parts replacement procedures
in this section. Also, read and adhere to the Warning and Caution information in Section 6.
WM048523 Rev 08 01/2019 205
14 Models with Metal Electronic Head - IEC
To Next Page
Loading...
