6.16.2 Backlight Replacement
1
Turn off power at the dispenser power switch.
2
Disconnect all cables from the TFT board (IEC only) and R2 board, and the DC cable on the
backlight board. See previous Fig 6.61.
3
Remove (2) Torx screws from the left side of the display bracket shown in previous Fig 6.62
and remove the bracket as shown in previous Fig 6.63.
4
Press on the tab, pull the backlight cable out a few inches and disconnect it from the backlight.
See Fig 6.67.
Figure 6.67: Release Tab
WM048523 Rev 08 01/2019 131
6 Replacement Procedures
To Next Page
Loading...
