6.14 Sales Display and Glass Replacement
The sales display and controller board are not separately replaceable. The service part is an
assembly.
The display glass is not separately replaceable. If the glass needs to be replaced, the glass
panel must be replaced.
6.14.1 Sales Display Assembly
A TORX screwdriver bit with a flexible shaft is required to remove the inside corner screws on
the boards.
1
Turn off power at the dispenser power switch.
2
Disconnect all cables from sales display board shown in Fig 6.41.
3
Remove (4) T20 Torx screws from the sales display/controller board assembly and remove
assembly.
4
Replace assembly. See Note below.
Note!
Be careful not to overtighten the screws as this will strip the threads on the plastic bezel.
Figure 6.41: Sales display board
114 WM048523 Rev 08 01/2019
6 Replacement Procedures
To Next Page
Loading...
