6.16 VGA and Backlight Replacement
The backlight can be replaced separately as explained in this section.
6.16.1 VGA Replacement
1
Turn off power at the dispenser power switch.
2
Disconnect all cables from the TFT board (IEC only) and R2 board, and the DC cable on the
backlight board. See Fig 6.61.
Figure 6.61: Disconnect cables
Note!
During the next step hold the display with one hand so it does not fall. The bracket slides into
the two slots on the right side; there are no screws on the right side.
WM048523 Rev 08 01/2019 127
6 Replacement Procedures
To Next Page
Loading...
