4.25 Wayne Connect IP-485
Optional Equipment
The Wayne Connect™ IP-485® network solution allows the customer to use the existing under-
ground pair of wires for CAT communications instead of pulling new underground Ethernet cable.
The module converts the RS-485 signals (delivered by the existing underground pair of wires)
to Ethernet compatible signals which are then sent to the iX board. The iX board then drives the
customer interface (the card reader, keypad, and display screen) either directly, or through the
SPM, if the dispenser has SPM.
The Wayne Connect IP-485 network switch is shown in Fig 6.81 in the Replacement Procedures
section.
DescriptionStatusConnector
Normal OperationGreenLED's
Unstable RS-485Yellow
Offline - Wiring/connections
bad, P7/P8 reversed
Red
4.26 Vapour (Vapor) Recovery
For IEC Burkert board, Expansion board, and Vapor Gate, see the manuals listed in the Hydraulics
section of this manual.
WM048523 Rev 08 01/2019 63
4 Board Layout and Connector Descriptions
To Next Page
Loading...
