Dover Wayne Helix WM048523 - Problem Symptoms and Solutions

Error Severity
Level
(Function 39)
CORRECTIVE ACTIONPROBABLE CAUSEDESCRIPTION
ERROR
CODES
1See Function 56Indicates time/date that
door/security was
armed/unarmed. Also indi-
cates door security method
being used.
Dispenser Security Armed
status change
Device #0 = Dispenser un-
armed
Device #1 = Dispenser
armed using One-Shot
97
Device #2 = Dispenser
armed using Maintenance
mode
98
30,1 = Replace Vac
board or cable. Replace
iGEM.
Hardware configuration
problem detected. Hard-
ware signal is missing.
Hardware/Software mis-
match
Device #
0 = No proportional hard-
ware
1 = No vapor recovery
hardware
2 = Meter type does not
match F16.04
3 = Ovation II - not enough
UPD’s installed
4 = Ovation II - too many
UPD’s installed
99
2 = Change meter or
template
3 = Change UPD
4 = Change UPD
* These errors can be a result of an iGEM code upgrade and should be ignored if occurring im-
mediately after a code change.
9.2 Problem Symptoms and Solutions
The corrective action listed in the table below is the most likely course of action to be taken to
correct the problem.
176 WM048523 Rev 08 01/2019
9 Error Codes, Problem Symptoms and Solutions - NA