For programming, refer to the iGEM Function Programming manuals WM048524 NA version
and WM048525 IEC version for details on iGEM functions and statistics.
Dispenser power
switch.
See AC power switch
Warning on previous
page)
Nozzle swich
converter board
Figure 6.1: iGEM and nozzle switch converter boards
6.2 Nozzle Switch Converter Board
The Nozzle Switch Converter board is shown in 6.1 on the previous page.
1
Turn off power at the dispenser switch located to left of the iGEM board.
2
Disconnect the cable to the ISB cable and the cable to iGEM.
3
Remove (2) Torx screws and remove board.
4
Install new board.
78 WM048523 Rev 08 01/2019
6 Replacement Procedures
To Next Page
Loading...
