14.2 Removing the Bezel
Referring to previous Figure 14.2, to replace the VGA display, display glass, or speakers, the
whole bezel/frame must be removed from the dispenser, and then disassembled as detailed in
this section.
The Main Mounting Bracket must be removed from the bezel frame and then components re-
moved from the main mounting bracket to access the VGA display. The main mounting bracket
must be removed also in order to replace the VGA softkeys, or the preset keypad.
The VGA fan, the sales display, R2 board, and the other circuit boards can be replaced without
removing the bezel frame or the main mounting bracket as shown later in this section.
Remove bezel frame as follows:
1
Open both bezels.
2
On the affected side, disconnect all cables that go over to the electronic head from the boards
on the bezel.
WM048523 Rev 08 01/2019 207
14 Models with Metal Electronic Head - IEC
To Next Page
Loading...
