1.2 Unlocking the Bezel
Perform the following the steps to open the bezel and payment terminal for service.
1
Unlock bezel U-frame shown in Fig 1.1, then raise the frame to the overhead position.
2
Unlock Payment Terminal Drawer. See lock location in Fig 1.2.
3
Locate the two latches, underneath the payment terminal, then firmly push up on latches and
pull out to unsnap. The latches are shown in detail in Fig 1.3.
4
Continue to pull the drawer out into the service position as shown in Fig 1.4.
Figure 1.1: Unlocking the Bezel
Note!
The typical dispenser bezel with payment terminal is shown above. A typical non-payment bezel
is shown in Figure 1.5.
8 WM048523 Rev 08 01/2019
1 Introduction
To Next Page
Loading...
