6.20 Low Profile USB Printer Replacement
1
Slide printer all the way out.
2
Disconnect the USB and power cables from the back of printer.
3
Push down on bracket latch behind printer while pushing printer inward. The three screws on
bottom of printer will slide out of the retaining slots on the bracket. Lift and remove printer.
Note!
It may be necessary to firmly push and tap the printer inward to release it from the slots.
4
It should not be necessary, but if the printer does not slide inward, loosen Phillips head screw
underneath the printer bracket, as shown in Fig 6.75, then push the printer inward.
Figure 6.75: Low Profile USB Printer
138 WM048523 Rev 08 01/2019
6 Replacement Procedures
To Next Page
Loading...
