8 iGEM Software Downloads - NA version
Follow the procedure below to upload/download pump code and templates.
1
Power down the pump.
2
Connect laptop via a Null Modem Cable to J26 on computer board.
3
Power up pump first, and then open the Service Terminal Program (servTerm) on the laptop.
4
Click on iGEM Connect.
5
At the enter Pass 1 prompt, click on Password.
6
Select Default Password.
7
Go to appropriate function below by entering or selecting function.
Table 8.1: Software Downloads
9998979695
To download template to
dispenser
To download code to
dispenser
To upload template
to PC
To upload code to
PC
To upload custom
template to PC
select template from file
or select Dispenser Type
select the _.bin file-
name
select the filenameselect the _.bin file-
name
select the filename
select dispenser Optionswaiting for flash to
erase
*
select saveselect saveselect save
click on Accept Settingsdownloading blocks
begins
uploading blocks be-
gins
uploading blocks be-
gins
uploading blocks be-
gins
waiting for flash to erase
*
download completeupload completeupload completeupload complete
downloading blocks be-
gins
select iGEM discon-
nect
select iGEM discon-
nect
select iGEM Discon-
nect
select iGEM Discon-
nect
download completepower down pumppower down pumppower down pumppower down pump
select iGEM disconnectdisconnect laptopdisconnect laptopdisconnect laptopdisconnect laptop
power down pumppower up pumppower up pumppower up pumppower up pump
*If this process is now interrupted for any reason, the Bootstrap procedure must then be used
to download to the dispenser, therefore, do not run other programs or perform other actions on
the desktop. See Bootstrap Procedure on the following page.
Also refer to the iGEM Function Programming manual WM048524 NA version for details on
iGEM functions and statistics.
168 WM048523 Rev 08 01/2019
8 iGEM Software Downloads - NA version
To Next Page
Loading...
