Dover Wayne Helix WM048523 - Softkeys and Glass Replacement

6.15.2 Softkeys and Glass Replacement
The softkeys are part of the rubber gasket shown in Fig 6.56. They are replaced as an assembly.
The glass is replaced separately.
Figure 6.56: Softkey/Gasket and Glass
1
Perform the steps in the previous section for removing the display.
2
After removing the display, remove 4 screws and remove display glass/softkey retaining
bracket in Fig 6.57.
bracket
screws
Figure 6.57: Glass and softkey bracket
3
Remove the softkey/gasket and glass assembly.
4
Remove the glass from the softkey/gasket.
5
Replace glass or the softkey/gasket as needed and reassemble.
124 WM048523 Rev 08 01/2019
6 Replacement Procedures