Read this manual before starting any installation, service, or maintenance work
Fuel dispensers contain both electrical components and a hazardous, flammable and potentially
explosive fuel. Failure to follow the below precautions and the Warning and Caution instructions
in this manual may result in serious injury. In addition, it is your responsibility to follow all rules,
codes, regulations, and laws that apply to your location and type of work being performed.
Safety precautions
Make sure that ALL power to the dispenser is turned OFF before opening the cabinet or starting
work. Physically lock, restrict access to, and/or tag the circuit breakers you turn off. In addition,
be sure to trip (close) all emergency valves under the dispenser (if installed) BEFORE you begin.
Make sure that you locate the facility’s emergency shut-off button, and know how to turn OFF
power to the dispenser and submersible pumps (if any) in an emergency.
Never allow a leaking pump to run! Use appropriate measures to clean up any fuel on the fore-
court, and ensure that any leaks or issues that could cause a leak are attended to and repaired
immediately.
Indicators and notations
Note!
Indicates extra information or tip.
NOTICE!
Highlights an essential element of a procedure to
help ensure accuracy, completeness, and appropriate
performance.
CAUTION!
Indicates a potentially hazardous situation, which if
not avoided, could result in personal (non-lethal) in-
jury or equipment damage.
WM048523 Rev 08 01/2019
To Next Page
Loading...
