8
Install new softkey. Be sure to reinstall the spring.
9
Repeat for opposite softkey as necessary.
Preset Keypad:
The preset keypad is replaced using similar steps as those used above for the VGA softkeys:
By removing the Main Mounting bracket from the bezel. Then, removing the preset keypad from
the mounting bracket. Shown below is an example for the non-media bezel bracket. On VGA
models, the preset keypad may be located underneath the fan, therefore, remove the fan
bracket from the main bracket, then remove the preset keypad screws, washers and springs.
WM048523 Rev 08 01/2019 229
14 Models with Metal Electronic Head - IEC
To Next Page
Loading...
