11
Enable Function and Softkeys as necessary. This will make the softkeys on the keypad mirror
the softkeys on the display panel.
12
Enable pump iSense as necessary.
13
Select Fixed length as necessary.
14
Select YES if the dispenser is using a Contactles Card Reader. Note that a Bill Acceptor and
a Contactless Reader cannot be attached and configured at the same time. These two devices
share the same COM Port. Answering YES to this prompt will enable the Contactless Reader
and the Transparent Mode screen will be displayed.
•
Answer NO at the Transparent Mode screen unless instructed to do otherwise for a specific
customer or vendor.
WM048523 Rev 08 01/2019 333
A iX Pay™ Secure Payment Configuration U.S. Version (Optional)
To Next Page
Loading...
