IECNADescription
√√Printer, Zebra
√√Heater/Fan, 300W, 24V
√iGEM Board* (existing part, but needs jumpers installed in
field)
√iGEM Board* (existing part, jumpers already manufactured
in the board)
√iGEM board*, small pump
√√WIP* for iMeter, black case
√√WIP* for Xflo meter, blue case
√√Gasket, SPM Keypad
√√Gasket, Card Reader
√√Proportional Valve, Note: Valve is the same but coil is differ-
ent between NA and IEC.
√VGA 10.4 Display*
√iX TFT Interface board*
√Led Quad Channel Backlight Board*
Table 5.2: Hydraulics
IECNADescription
√√iMeter* (existing same serv part as previous models, the
base and strainer casting is new)
√√Check Valve, iMeter, (existing part)
√√O-ring, iMeter check valve, (existing part)
√√Xflo* (existing same serv part as previous models
(base/strainer casting is new)
√√Check Valve, Xflo meter, (existing part)
√√O-ring, Xflo meter check valve, (existing part)
√√Lock Pin, valve tube
√√Retaining Clip, outlet casting tube
√√O-ring for triple bump tube
70 WM048523 Rev 08 01/2019
5 Parts and Tools Reference
To Next Page
Loading...
